Skylink TOTAL PROTECTION SC-100 - Manual (Page 15)

– 18 – – 15 –
TO ARM SYSTEM USING THE KEYCHAIN TRANSMITTER
There are 2 different arm options to choose from:
1. Press button #1, and the Control Panel will beep once.
The system will be armed in the Away Sequence. To be used to arm the system
when you are the last person leaving the premises. (see page 12 for informa-
tion on the Away Sequence).
Pressing button #1 will give you the same result as pressing:
MPIN, [ B ] , [ C ] on the keypad.
2. Press button #2, and the Control Panel will beep once.
The system will be armed in Home Sequence. To be used to arm the system
when someone remains in the premises. (see page 12 for information on
the Home Sequence).
Pressing button #2 will give you the same result as pressing: MPIN, [ C ] on the
keypad.
The Keychain Transmitter conveniently fits on any keychain. It allows you to arm
and disarm the system from a distance of approximately 100 feet from the Control
Panel. The distance will depend on what is between the keychain transmitter and
the Control Panel. It also has a panic button that lets you remotely activate the
siren instantly.
Note: Make sure you press down on the transmitter for one full second or the
system may not respond.
KEYCHAIN TRANSMITTER (4B-434)
PANIC
2
1
3
SECONDARY PERSONAL IDENTIFICATION NUMBER (SPIN)
You may want to give someone limited access to the system, (baby sitter, cleaner,
repairman etc.). For this purpose the SC-100 provides you with the option of
adding up to 3 separate SPIN.
A SPIN can be any number of 3 digits or more. You can use a SPIN to arm and
disarm the system but not to program it, (programming is explained in the next
section). When someone no longer needs to have access to your security system,
you can simply delete their SPIN.
Adding a SPIN
1. Enter the current MPIN.
2. Press [ * ].
3. Press the number key to identify user, either [ 1 ], [ 2 ] or [ 3 ].
4. Press [ * ].
5. Enter the new SPIN (your SPIN must be a minimum of 3 digits).
6. Press [ * ].
If the system accepts the new SPIN, you will hear a long beep. If you hear three
short beeps, the system did not accept the new SPIN. Start again.
Deleting a SPIN
1. Enter the current MPIN.
2. Press [ * ].
3. Press the number to identify the user, either [ 1 ], [ 2 ] or [ 3 ].
4. Press [ * ].
5. Press [ * ] one final time.
If the SPIN was successfully deleted, you will hear a long beep.
PASSWORDS