Sennheiser SKP 500 - Manual (Page 25)

25
Recommendations and tips
... for the plug-on transmitter
y Use microphones with a metal casing, since the
transmitter uses the microphone body as an antenna.
y You can vary the bass reproduction by increasing/
decreasing the talking distance.
y For best results, make sure that the transmitter
sensitivity is correctly adjusted.
... for optimum reception
y Transmission range depends to a large extent on location
and can vary from about 10 m to about 150 m. There
should be a “free line of sight” between transmitting and
receiving antennas.
y To avoid overmodulating the receiver, observe a
minimum distance of 5 m between transmitting and
receiving antennas.
... for multi-channel operation
y For multi-channel operation, you can only use the
channels in a channel bank. Each of the channel banks “1”
to “8” accommodates up to 20 factory-preset frequencies
which are intermodulation-free. For alternative frequency
combinations, please refer to the enclosed frequency
table. The freely selectable frequencies can be selected
via the “
TUNE ” menu and can be stored in the channel
bank “U”.
y When using several transmitters simultaneously,
interference can be avoided by maintaining a minimum
distance of 20 cm between two transmitters.
Care and maintenance
Use a slightly damp cloth to clean the transmitter from time
to time.
Note:
Do not use any cleansing agents or solvents.