Painting the speakers and grilles, Specifications, 6sonance cinema – Sonance HOME THEATER SPEAKERS User Manual

Page 6: Select

SONANCE CINEMA

SELECT

6. Tighten the four screws on the front of the speaker baffle. The RotoLock clamps will automatically

rotate into position and begin clamping the speaker (Figure 11).

• When you notice resistance on the screws the speaker has been clamped successfully.

IMPORTANT: Always use low-torque settings; NEVER over-tighten.

OTE

: T

HE SPEAKER FLANGE IS DESIGNED TO FLEX AND CONFORM TO ANY SMALL IMPERFEC

TIONS IN THE WALL SURFACE

. D

O NOT TIGHTEN THE SCREWS SO MUCH SO THAT THE FLANGE

BOWS

OUT

7. Attach the grille after the speaker has been installed. Insert about half of the grille into the groove

at the edge of the speaker. Gently fit the remaining half of the grille by working around the speak-

er, fitting the grille into the groove as you go.

OTE

: Y

OU CAN ADJUST THE TORQUE APPLIED TO THE

OTO

OCK SCREWS TO ACHIEVE A PROP

ER GRILLE FIT

PAINTING THE SPEAKERS AND GRILLES

You can paint the speakers and grilles before installing them, which will eliminate the “paint scar” that

can be left on the wall if the speaker ever needs to be removed for service. You can also paint the

speakers after installation, but before the grilles are attached. All Sonance Symphony speakers come from

the factory fitted with a plastic ‘paint plug’ that protects the speaker drivers while the mounting flange

is being painted.
Sonance always suggests painting the grille separately from the speaker. Before painting, carefully remove the under-grille cloth. It is held in place with a

light tacking glue that makes it easy to remove.
Spray the grille with thinned paint (5 parts thinner to 1 part paint), being careful not to plug the holes. Too heavy a coat of paint on the grille will

adversely affect the sound of the speaker.
Once the grille and flange are painted and dry, replace the under-grille cloth, remove the paint plug from the mounting flange and install the grille.

SPECIFICATIONS

RotoLock

Clamps

F i g u r e 1 1 :

T i g h t e n i n g t h e R o t o L o c k C l a m p s

Cinema Select LCR

Tweeter:

1" (25mm) Silk dome, Ferrofluid-cooled,

shielded magnet

Woofer:

6½" (165mm) Carbon fiber cone, rubber

surround, shielded magnet

Frequency Response:

80Hz – 20kHz ±3dB

Impedance:

8 Ohms nominal; 5 Ohms minimum

Power Handling:

5 watts minimum; 135 Watts maximum

Sensitivity:

90dB SPL (2.83V 1 meter)

Grille Material:

Perforated aluminum

Adjustments:

None

Dimensions (W x H x D):

8¼” x 12

" x 3

(210mm x 310mm x 98mm)

Cutout Dim. (W x H):

" x 10

" (172mm x 270mm)

Shipping Weight:

5 lbs. (2.3kg) Each

Cinema Select SUR