SECO-LARM USA Enforcer E-37EV - Manual (Page 6)

ENFORCER E-37EV Alarm Pager System
6 SECO-LARM U.S.A., Inc.
1
2
0
V
A
C
Transmitter
ID
Input
Receiver Display
Page LED Zone LED
Audible / Vibrator
Indicator
Green
Positive Trigger Green Green Groups of 9
Negative Trigger #1 Green Red Groups of 9
Negative Trigger #2 Green Orange Groups of 9
Manual Page Green Green 3 groups of 3
Power ON Green None 3 groups of 3
Red
Positive Trigger Red Green Groups of 9
Negative Trigger #1 Red Red Groups of 9
Negative Trigger #2 Red Orange Groups of 9
Manual Page Red Green 3 groups of 3
Power ON Red None 3 groups of 3
Orange
Positive Trigger Orange Green Groups of 9
Negative Trigger #1 Orange Red Groups of 9
Negative Trigger #2 Orange Orange Groups of 9
Manual Page Orange Green 3 groups of 3
Power ON Orange None 3 groups of 3
Audible and Visual Signals Chart
Operation
Receiver Switch Settings
 : Beeping only ON : Vibration only OFF: Receiver off
Trigger Duration
 The transmitter will transmit the page signal for a cycle of about 30 seconds, whether or not
the triggered zone is reset. If the same zone remains triggered, the transmitter will not start
a new transmission cycle. However, a new cycle will begin once another un-triggered zone
is triggered.
Manual Paging
 When triggered by the manual page button the receiver will beep (or vibrate) continuously
for 1 minute in 3 groups of 3.
 The Page LED will indicate which transmitter is sending the signal (Green, Red, or Orange).
 The Zone LED will flash green.
 Press the ON / /OFF button after 30 seconds to stop the indicator.
Power-On Paging
 When the transmitter is connected to power the receiver will beep (or vibrate) continuously
for 1 minute in 3 groups of 3.
 The Page LED will indicate which transmitter is sending the signal (Green, Red, or Orange).
 The Zone LED will remain blank.
 Press the ON / /OFF button after 30 seconds to stop the indicator.