Siemens PEGASUS-DTC AX72 - Manual (Page 7)

7 Switch on/off, PIN
right page (7) of AX72 Pegasus-DTC, FUG, en, A31008-H2860-A1-1-7619 (06.10.2005, 08:28)
©
Sie
m
en
s A
G
200
3,
C:\D
at
en
_itl\S
iem
en
s\D
TP-S
atz\Pr
odukt
e\A
X
72_Pegasus_
D
TC\out-
VA
R Language:
en; V
A
R is
sue dat
e: 05
0613
When charging is in progress
h
is
displayed.
Charging time
An empty battery is fully charged after
about 2 hours. Charging is only possible
within a temperature range of
+5 °C to +40 °C. If the temperature ris-
es/falls 5 °C above/below this, the charge
symbol flashes a warning. The mains
voltage specified on the power supply
unit must not be exceeded (Operating
time, p. 35).
Charge icon not visible
If the battery has been discharged fully
the charge icon is not immediately visible
when the power supply unit is plugged
in. It will appear after up to two hours. In
this case the battery is fully charged after
3-4 hours.
Only use the power supply unit provided!
Display while in service
Charge level display during operation
(empty - full):
a d g
.
A beep sounds when the battery is nearly
empty. The charge level of the battery is
only displayed correctly after an uninter-
rupted charging/discharging cycle. You
should therefore not remove the battery un-
necessarily and where possible not termi-
nate the charging process early .
Switch on/off, PIN
Switch on/off
Press and hold the On/Off/End key
B
to
switch on or off.
Enter PIN
The SIM card can be protected with a
4- to 8-digit PIN.
Enter the PIN using the number keys. The
characters
****
appear to ensure no-
body can read your PIN on the display.
Correct errors with §Clear§ .
Confirm your input with §OK§ . Logging on
to the network will take a few seconds.
Emergency number (SOS)
Only to be used in real emergencies!
By pressing the soft key §SOS§ you can
make an emergency call on any network
without a SIM card and without entering a
PIN (not available in all countries).
Switching on your phone for the
first time
Time/date
Set the clock to the right time once at
start-up.
Press
§Yes§ . First enter the date
(day/month/year), then the time
(24 hours, including seconds). Press §OK§ .
The time and date are updated.
If the battery is removed for longer than
30 seconds, the clock will be reset.
Time zones
Set the time zone for your area.
Select the required time zone from list
with
G
. Apply with §Set§ .