Siemens PEGASUS-DTC AX72 - Manual (Page 6)

Getting started 6
© Sieme
ns A
G
2003, C:\Dat
en
_i
tl\Si
emens\D
TP-
Satz\Pr
odukt
e\AX72
_P
eg
asus_D
TC
\o
ut-
left page (6) of AX72 Pegasus-DTC, FUG, en, A31008-H2860-A1-1-7619 (06.10.2005, 08:28)
VA
R Language:
en; V
A
R is
sue dat
e: 05
0613
Getting started
Using the SIM card/battery
Your phone's display is delivered with a
protective film. Remove this film before get-
ting started . The service provider supplies
you with a SIM card on which all the im-
portant data for your account is stored. If
the SIM card is credit card-sized, snap out
the smaller segment and trim any rough
edges.
Press depression
1
to remove the
cover downwards in the direction of the
arrow
2
.
Insert SIM card
3
and push it fully into
the locating slot (make sure the angled
corner is in the correct position
4
).
To remove the SIM card push the card
here
5
.
Insert the battery sideways into the
phone
6
, then press downwards
7
until it engages.
To remove, press the retaining tab
8
then lift the battery out.
Place cover on phone and push to the
upper edge, until it clicks into place
9
.
Always switch off phone before removing
the battery!
Only 3V and 1.8V SIM cards are support-
ed. Please contact your service provider if
you have an older card.
Charge battery
The battery is not fully charged when de-
livered. Plug charger cable into the bot-
tom of the phone, plug power supply unit
into a mains power socket and charge for
at least two hours. The power supply unit
heats up when used for long periods. This
is normal and not dangerous.
1
2
3
4
5
7
8
6
9