Sirius Satellite Radio SRH2000 - Manual (Page 25)

25
Visit the SR-H2000 support page at www .sirius .com for additional
downloadable remote control files .
12 Volt Trigger Information
The 12V Trigger Input allows your 12V-trigger-capable preamp or receiver
to force the SR-H2000 Tuner to go from STANDBY mode (power button
illuminated, front panel display off) into ON mode (power button not
illuminated, front panel display on) or vice versa without the need to press
the POWER button .
To enable this feature, connect a 1/8” mono plug cable (tip + / sleeve — ) from
your preamp or receiver’s 12V Trigger Output to your Tuner’s 12V Trigger
Input jack on the rear panel . So long as the Tuner stays plugged into an active
AC outlet, your Tuner is ready to respond to power mode changes sent from
your preamp or receiver .
To disable the 12V Trigger Input feature, simply do not connect anything to
the 12V Trigger Input jack on the rear panel of the Tuner .