Sanyo SC-150 - Manual (Page 8)

USING THE VACUUM CLENER
UPHOLSTERY TOOL & DUSTING BRUSH
(SC-180 only)
TURBINE BRUSH
(SC-180 only)
7
The turbine brush has a lever with two
positions. This rug attachment has a small, built-in
turbine that is driven by the suction force
of the unit. The turbine drives a brush
inside the attachment to pick up fine
particles more efficiently.
Caution:
Do not touch the agitator while it is spinning.
Do not vacuum bare floors with lever in "rug" position. Doing so may damage the floor.
Do not leave the brush rotating for long periods over the same spot. Doing so may
damage the carpet.
R
U
G
F
L
O
O
R
Lever
RUG FLOOR
Turbine
Brush
Tabs
Press the tabs downward to remove the dusting brush from the
upholstery tool.
Insert the front portion of the dusting brush into the groove located
inside the front of the upholstery tool.
Pull up on the tabs to reattach the dusting brush to the upholstery tool.
After use, fix to the extension pipe for storage as shown in the illustration.