Sennheiser HD 280 - Manual (Page 9)

8
Replacing the connecting cable
Replace the connecting cable if it is damaged. To do so, please
proceed as follows:
̈
Remove the ear cushion. Grasp behind the ear cushion and
pull it up and away from the earcup.
̈
Loosen the screw
ᕡ
and remove it.
̈
Remove the cover from the earcup
ᕢ
.
̈
Pull the connector
ᕣ
out of the socket.
̈
Remove the antikink protection of the connecting cable
from the holding device
ᕤ
.
̈
Insert the antikink protection of the new connecting cable
into the holding device.
̈
Plug the connector
ᕣ
of the new connecting cable into the
socket as shown in the diagram on the left.
̈
Put the cover back onto the earcup
ᕢ
.
̈
Replace the screw
ᕡ
and tighten it.
̈
Slide the ear cushion onto the earcup.
Converting the headphones into a headset
If you wish to convert your headphones into a headset, please
contact your Sennheiser service partner who will equip the
headphones with a microphone.
ᕣ
ᕤ
ᕢ
ᕡ