Sunrise Medical Kid Kart Xpress - Manual (Page 40)

0
9921700000 Rev C mkt3048
V I I I . M A I N T e N A N C e
1. Spray tilt in space control plunger with Teflon-based lubricant every six months to ensure
continued smooth operation. The spray can be purchased at most bike shops and hardware stores.
2. At least every four months, check all screws and knobs for tightness. If parts are missing, broken,
damaged or won, then stop use of the product until repairs are made, using factory-authorized
parts.
3. Wipe down all plastic components periodically with disinfectant solution to maintain cleanliness.
4. Hand wash and air-dry the fabric components as needed.
5. Check tire pressure once a week. Refer to the pressure recommendations printed on the tire side
wall (typically 35 psi).
6. Lubricate all moving components with Teflon lubricant only.
caution
Use of any other types of lubricant tend to foul moving components
and may void warranty.
7. Check the wheel locks for proper operation. Rear wheels should skid rather than roll when pushed
with a child in the product.
8. If the release lever is not returning to its locked position or if the locking mechanisms are not
catching and locking the rear axil for transport, inspect them for any build up of dirt or grit. If dirt is
present, the parts may be washed with warm soapy water, dried thoroughly and then relubricated
with a teflon based lubricant from a bike shop or hardware store. Always check to assure this
procedure corrected the problem. If there is not a build up of dirt or grit, the lubricant will help
mechanisms function smoothly.