Sunrise Medical Kid Kart Xpress User Manual
Page 26
2
9921700000 Rev C mkt3048
V I I . O p e R A T I N G I N s T R U C T I O N s
M. pOsITIONING AND GROWTh ADJUsTMeNTs GUIDe
If necessary, a healthcare professional should make any changes to
the positioning and growth adjustments. These adjustments are very
important to the orthopedic and neurological needs of the child.
Care should be taken to make sure they are appropriate.
Use the 5/32" hex head tool provided or an electric screwdriver with a 5/32" hex head bit to adjust the
seating and positioning system. The enclosed hand held hex bit wrench is ergonomically designed to work
at many angles. An electric screwdriver with a 5/32" hex head bit is useful when doing several fittings.
However, care must be taken to not over-loosen or over-tighten the screws.
In general, positioning and growth adjustments should be done in the following order:
1. Adjust seat
2. Adjust back
3. Adjust pelvic positioning belt
4. Adjust footbed
5. Adjust head support
6. Make other standard and optional adjustments needed
7. Check to be sure that all adjustment screws are tight
N. seAT DepTh ADJUsTMeNT
1. Determine the proper seat cushion depth.
2. Remove the seat cushion. It is attached with
Velcro®.
3. Loosen the seat depth adjustment screws found
on each side of the frame from under the seat
base.
4. Once they are loose, grasp the bar under the
front edge of the seat and slide to the desired
length.
5. Re-tighten all four adjustment screws once the
desired position is achieved. (See Fig. 20)
Figure 20
!
WARNING