Sunrise Medical Kid Kart Xpress - Manual (Page 22)

22
9921700000 Rev C mkt3048
V I I . O p e R A T I N G I N s T R U C T I O N s
e. TRANsIT Use
1. If possible and feasible, the rider should transfer to the
vehicle seat and use the vehicle restraints.
2. If the mobility base is used for transport, it must be
used with occupant facing forward in the vehicle,
except for infants. (See page 16, 2a and 2b.)
3. The occupant must not weigh more than 55 pounds.
4. The location of the securement points is shown. (See
Fig. 13, A)
5. Use only with WTORS that have been installed in
accordance with the manufacturer's instructions and
SAE J2249.
6. Attach WTORS to the securement points in accordance
with the manufacture's instructions and SAE J2249.
7. Attach occupant restraints in accordance with the
manufacturer's instructions and SAE J2249.
Note: To obtain a copy of SAE J2249 Wheelchair Tiedown and Occupant Restraint Systems for
Use in Motor Vehicles, please contact: SAE International on the internet at www.sae.org/ or by
phone at (724)-776-4841.
F. pOsITIONING sheLL INsTALLATION
Figure 13
Forward Position
Reversed Position
The positioning shell has a pivot post on each side that mounts the shell to the mobility base. The mobil-
ity base has a slot on each side that receives the shell pivot posts. The shell will not install onto, nor
remove from, the mobility base when the mobility base push handle is folded. The positioning shell may
be installed in a child facing forward or rearward position. Installation is the same either direction.