Siemens ULTRASENSE WTXD5300US - Manual (Page 17)

16
Safety
information
d DANGER d
Always follow the IMPORTANT
SAFETY INSTRUCTIONS
(see page 4).
d DANGER d
EXPLOSION HAZARD!
Keep flammable materials and
vapors, such as gasoline, away
from the dryer.
Do not dry anything that has ever
had anything flammable on it
(even after washing).
Do not dry anything that has ever
had any type of oil on it (including
cooking oils).
Items containing foam, rubber or
plastic must be dried on
a clothesĆline or by using an
Air fluffĆcycle.
Do not allowed items
containing flammable
materials, such as lighters, to
remain in clothes while drying.
Failure to follow these
instructions may result in
explosion or fire.
Risk of death or injury!
Use the dryer only in the house and
for drying normal amounts of
laundry for the household.
Use only for drying textiles which
were washed with water.
Before switching
on the dryer
Install the dryer in accordance
with the installation instructions
(from page 6).
Do not use a dryer which is visibly
damaged. If in doubt, contact your
dealer.
Using the dryer
Do not leave children unsupervised
near the dryer.
Keep pets away from the dryer.
Before closing the door, check the
contents of the drum.
Remove all objects from pockets.
Lighters are particularly hazardous.
Risk of explosion!
Switch off the dryer at the end of
the program.
Protecting the dryer
Do not climb on the dryer.
Do not lean or sit on the door.
Risk of dryer tipping over!
Do not store or use solvent
detergent boosters or stain remover
in the vicinity of the dryer.
The dryer could be damaged.
Do not lift the dryer by projecting
components.
Risk of breakage!
Risk of injury!
Protection
of the
environment
Tips on saving energy
To save energy, money and time,
Siemens recommends the
following:
- Drain the laundry thoroughly!
Before drying, spin the laundry
thoroughly in the washing
machine. Use the highest
possible spin speed for the type
of laundry! Higher spin speeds
reduce the drying time and the
energy consumption.
- Use optimum load!
Use maximum recommended
loads. However, do not exceed
loads.
- Clean filter!
Clean the filter before and after
each drying process
(see page 23).
- Ventilate the room!
During the drying process
provide an adequate supply
of fresh air.
- Do not dry unsuitable
materials!
Do not dry rubberized or
airĆtight items.
- Do clean and inspect the
exhaust system on a regular
basis!
Blockages may extend drying
time.