Woodstock REBEL W2000 - Manual (Page 12)

W2000 Rebel ® – 11
A A.. R Ro ou utteerr T Taab bllee IIn nsseerrtt
Located in the four corners of the insert ledge on the
table are four holes. These holes are threaded to accept
the 10-32 x
3 ⁄
4
" setscrews provided. F Fiig gu urree 1 14 4. The
setscrews are turned in or out from underneath to
adjust router table insert flush with the table.
IIIIII.. A Ad djju ussttm meen nttss
To adjust the router table insert:
S Stteep p 1 1 - Use a good quality straightedge and place it
on the table surface so it rests above one cor-
ner of the router table insert. F
Fiig gu urree 1 15 5.
S Stteep p 2 2 - Loosen the jam nut and turn the leveling
setscrew in or out so that the router table
insert just touches the straightedge.
S Stteep p 3 3 - Repeat this procedure for the other three
corners.
S Stteep p 4 4 - Re-check each corner and make fine adjust-
ments if necessary. Once the insert is level,
tighten down all four jam nuts.
F Fiig gu urree 1 14 4.. Leveling setscrew and jam nut.
F Fiig gu urree 1 15 5.. Checking insert for flushness.