Sony SMP-NX20 - Manual (Page 26)

26
, When you connect the player to a TV
through an AV amplifier (receiver),
– if the AV amplifier (receiver) is not
compatible with the “Control for HDMI”
function, you may be unable to control
the TV from the player.
– if you change the HDMI connection,
disconnect and reconnect the AC power
cord, or a power failure occurs, try the
following:
1 Switch the input selector of
the AV amplifier (receiver) so that the
picture from the player appears on the
TV screen.
2 Set “Control for HDMI” to
“Off,” then set “Control for HDMI” to
“On” (page 22). Refer to the instruction
manual supplied with the AV amplifier
(receiver).
The System Power-Off function does not
work (BRAVIA Sync).
, Check that “Control for HDMI” and
“HDMI: Linked to TV-off” are set to “On”
(page 22).
Playback does not start from the
beginning of content.
, Press OPTIONS, and select “Play from
beginning.”
Playback does not start from the resume
point where you last stopped playing.
, The resume point may be cleared from
memory when
– you disconnect the USB device.
– you play other content.
– you turn off the player.
The player does not respond to any button.
, Replace the battery in the remote with a
new one if it becomes weak.
, Press the reset button on the bottom of the
player.
, If the player still does not respond to the
reset button, disconnect then reconnect the
AC power cord.
Specifications
Inputs and outputs
(Jack name:
Jack type/Output level/Load impedance)
LINE OUT R-AUDIO-L:
Phono jack/2 Vrms/10 kilohms
DIGITAL OUT (OPTICAL):
Optical output jack/–18 dBm
(wave length 660 nm)
HDMI OUT:
HDMI 19-pin standard connector
COMPONENT VIDEO OUT
(Y, P
B
, P
R
):
Phono jack/Y: 1.0 Vp-p/
P
B
, P
R
: 0.7 Vp-p/75 ohms
LINE OUT VIDEO:
Phono jack/1.0 Vp-p/75 ohms
LAN (100):
100BASE-TX Terminal
USB:
USB jack Type A (For connecting a USB
memory, memory card reader, digital still
camera, and digital video camera)
DC IN:
12 V DC
Wireless
Wireless LAN standard:
IEEE802.11b/g/n
Frequency range:
2.4 GHz band: Channels 1-11
Modulation:
DS-SS Modem and OFDM Modem
General
Power requirements:
AC adapter: 110–240 V AC, 50/60 Hz
Power consumption:
11 W
Dimensions (approx.):
150 mm × 150 mm × 43 mm
(6 in. × 6 in. × 1
3 /
4
in.)
(width/depth/height) incl. projecting parts
Mass (approx.):
420 g (14 3 /
4
oz)
Operating temperature:
5 ºC to 35 ºC (41 °F to 95 °F)
Operating humidity:
25 % to 80 %
Others