Siemens S7 - Manual (Page 17)

Colour monitor S7
A26361-K877-Z100-4-5E19 English - 15
Storable display modes: 19 display modes (11 are preset, 8 are user-defined)
Electrical data
Video: analogue, positive, 0.7 V
pp
, 75 Ω
Synchronisation: Separate Sync. TTL, positive or negative
Horizontal frequency: 31 kHz .... 80 kHz (multi-scanning)
Refresh rate: 60 Hz .... 75 Hz
Maximum pixel rate: 135 MHz
Power supply: 100 V - 240 V
Audio output: 2 x 3 W
Total power consumption (typical): < 35 W (ON, Normal mode)
< 4,5 W in the energy-saving mode (standby mode,
suspend mode and OFF mode)
Environmental conditions
Environment class 3K2, IEC 721
Rated range of operation:
Humidity: 15 °C .... 35 °C
20 % .... 85 %
Limit range of operation:
Humidity: 5 °C .... 35 °C
20 % .... 85 %
Condensation must be avoided.
i Important information on audio playback
To achieve optimum sound quality from the monitor speakers, the audio cable should be
connected to the Line-Out socket (headphone socket) of the computer.
if you connect the audio cable to the Speaker-Out socket (soundcard) of the computer,
you should not set the volume under Windows to higher than 20 % of the maximum
value, as otherwise the sound signal will be distorted.
VESA-DDC-compatible VGA interface
Your monitor is equipped with a VESA-DDC-compatible VGA interface. VESA-DDC (Video
Electronics Standard Association, Display Data Channel) is used as the communications interface
between the monitor and the computer. If your computer is equipped with a VESA-DDC-compatible
VGA interface, it can automatically read the data for ensuring optimum operation from your monitor
and select the appropriate settings.
i
If the monitor S7 is not yet displayed in the list of monitors, you can select the following
monitor instead:
Fujitsu Siemens 4311FA, 4611FA, 4612FA, CTM 7010, CTM 7011, 461VFA