Woodstock W1798 - Manual (Page 8)

Model W1798 Professional Spray Gun
-6-
Assembly
1. Attach the air hose to the spray gun
with the included male 1 ⁄
4
" NPT quick
connect fitting.
Note: You have the option of attach-
ing a regulator/guage directly to the
gun. Some may find this awkward
and would rather mount the regula-
tor/gauge closer to the air source.
2. Attach the spray gun to an air supply
regulated between 43–58 PSI.
Note: For the best results, use a hose
that will be dedicated for spray use
only. Do not use a hose that has been
used with an in-line oiler.
Refer to the list below and see Figures
2 and 3 to become familiar with the
paint gun controls.
1. Fluid Control: Controls the volume
of paint that travels through the
atomizing cap.
2. Pattern Control: Adjusts the spray
pattern from a round pattern to a
wide fan.
3. Atomizing Cap: Controls the spray
pattern from vertical to horizontal.
4. Trigger: Two stage trigger. Stage
one only releases compressed air for
blowing off the work piece. Stage two
sprays material.
5. Reservoir: Easy-clean spun aluminum
canister, which holds a variety of
thinned and non-thinned paints and
lacquers.
6. Reservoir Quick Release Lock: Quick
removal and installation of reservoir.
Controls
Figure 3. Small paint gun controls.
Atomizing
Cap Reservoir Quick
Release Lock
Pattern Control
Fluid
Control
Air Supply Port
Figure 2. Large paint gun controls.
Pattern Control
Atomizing Cap
Reservoir Quick
Release Lock
Fluid Control
Air Supply Port
Trigger
Trigger
Reservoir
Reservoir