Sanyo VPC-R1E - Manual (Page 78)

Problem Cause & Solution P.
The flash does
not work. The flash off mode is set.
43 ⇒Set the flash to the forced flash mode or
automatic flash mode.
The camera has detected that the subject is bright
enough and does not require the flash.
—
⇒This is not a malfunction. Take the picture as is.
The batteries are consumed.
15
⇒Replace with new batteries.
The brightness
doesn’t change
in AE shift shots. The exposure may not change in some instances,
depending on the surrounding brightness.
—
⇒This is not a malfunction.
Flare (lines or
patterns of light)
appears in the
picture. Flare may appear in pictures where the subject is
lit from behind.
⇒Avoid photographing subjects that are
positioned in front of bright light sources.
When used in
cold weather,
the image may
seem to leave
traces as it
moves. A phenomenon due to the characteristics of the
liquid crystals.
—
⇒This is not a malfunction. The dots appear on
the LCD monitor screen but are not recorded in
the image.
Shining red,
blue or green
dots appear on
the screen, or
small black dots
are visible. A phenomenon due to the characteristics of the
liquid crystals.
⇒This is not a malfunction. The dots appear on
the LCD monitor screen but are not recorded in
the image.
The area
around the LCD
monitor is warm. A phenomenon due to the construction of the
internal parts.
⇒This is not a malfunction.
When taking a
picture, the
image is not
displayed on
the LCD
monitor. The main switch is set to [MONITOR OFF].
23
⇒Set the main switch to [Õ].
The playback
image is not
displayed. The main switch is not set to [ Ô].
29
⇒Set the main switch to [Ô].
Sh
oo
ti
ng
L
CD m
o
n
it
o
r
TROUBLESHOOTING
73 English