Star Trac SPINNING 727-0083 - Manual (Page 15)

12
Syncing Process:
Tools required:
Coin (penny, dime, etc.) or similar item to remove battery cover
Steps to Syncing:
Removing the battery lid on the backside of the Spinning
®
Computer and insert or replace the
4 AA batteries.
2. Once the batteries are installed, press any button and the display window will go into the
orkout mode.
Workout Mode
window
Holding the cadence sensor, remove the battery cover from the back of the cadence sensor
using the coin or similar object and take out the battery.
CAUTION: SYNC ONE BIKE AT A TIME, the range for the cadence sensor is
approximately 30 feet and if you are testing the bike and someone else on the same
room is pedaling another bike you may be picking up the wrong RPM signal.
Syncing Mode