Sony SRX-R210 - Manual (Page 6)

6
Shown: ApolloWall-Pro from HoloVis (www.holovis.com)
Colour Space Conversion
(CSC) function
The SRX-R220 and SRX-R210 feature a Colour Space Conversion
(CSC) function, which helps users easily adjust the projector’s
colour space to that which is defined in the DCDM (Minimum
D-Cinema Colour Gamut) or ITU-R BT.709.
The target colour gamut parameters required to meet the
DCDM or ITU-R BT. 709 standards can be automatically calculat-
ed from settings on the supplied SRX Controller software and
then applied to the projector. The internal test generator simpli-
fies adjustment and lets the operator align the projector in min-
utes.
12-bit LCD Driver
The SRX-R220 and the SRX-R210 utilise a 12-bit imager driver for
reproducing extremely natural images.
Gamma Curve Selection
The SRX-R220 and the SRX-R210 provide three preset gamma
curve values. Users can select an optimum value from 1.8,
2.2 and 2.6 according to the desired colour tone. A 2.6 gamma
setting is automatically selected for feature exhibition.
Squeeze Mode Function
The SRX-R220 and SRX-R210 allows squeezed images (16:9
or 1.896:1) to be changed to 2.39:1 un-squeezed images.
This can be done electrically without an anamorphic lens and
be activated by the SRX Controller software.
Keystone Masking
The SRX-R220 and SRX-R210 provide an image-masking function
to compensate for image distortion that typically occurs when
it has not been possible to install the projector perpendicular to
the screen. These projectors provide keystone masking for both
flat and curved screens.
Zoom/Focus Memory Function
The SRX-R220 and SRX-R210 are equipped with zoom and focus
memory functions that make it easy to switch the projection
between two types of aspect ratios.
When used with the optional motorised zoom lens LKRL-Z114C,
LKRL-Z116C, LKRL-Z117, LKRL-Z119, or LKRL-Z122 , the zoom and
focus positions for 1.85:1 motorised and 2.39:1 CinemaScope
™
can be stored and instantly recalled via the SRX Controller soft-
ware. This allows for full-screen display regardless of the aspect
ratio. An electronic vertical alignment feature is included in the
same memory to compensate for vertical changes in the image
should the projector be mounted at a downwards angle.
Operational Features
Select 4 corner positions to mask the area outside the perimeter
For curved screens, select 2 positions at the apex of the curve,
one at the top and one at the bottom of the screen.
Masked
area