Sanyo PLC-WXU30 - Manual (Page 12)

1
Part Names and Functions
Top Control
q
w
e
t
u
i
o
w LAMP REPLACE indicator
Lights yellow when the projection lamp reaches its
end of life (pp.65, 71).
i WARNING indicator
– Lights red when the projector detects an abnormal
condition.
– Blinks red when the internal temperature of the
projector exceeds the operating range (pp.62, 71).
e ON/STAND–By button
Turn the projector on or off (pp.22–23).
o POWER indicator
– Lights red when the projector is in stand-by mode.
– Lights green during operations.
– Blinks green in the Power management mode
(p.52).
r INPUT button
Select an input source (pp.30–31, 40–41).
!1 MENU button
Open or close the On-Screen Menu (p.24).
y POINT ed7 8 (VOLUME +/–) buttons
– Select an item or adjust the value in the
On-Screen Menu (p.24).
– Pan the image in the Digital zoom + mode (p.39).
– Adjust the volume level (Point 7 8 buttons) (p.27).
q ALARM indicator
Blinks red when informing the setting or battery
status (pp.58–59).
r
y
!0 AUTO SETUP/CANCEL button
–Correct vertical keystone distortion and adjust
computer display parameters such as Fine sync.,
Total dots, and Picture position (pp.26, 47).
–Display the image in SD card or return to the
menu bar in Memory Viewer menu.
Refer to the owner's manual of "Network Set-up
and Operation" and owner's manual of Memory
viewer.
!0
!1
u SELECT button
– Execute the selected item (p.24).
– Expand or compress the image in the Digital zoom
mode (p.39).
t KEySTONE button
Correct keystone distortion (pp.26, 48).