Make connections, Set the recorder’s input mode, Locate the start point – JVC HR-S8700EU User Manual
Page 55: Engage the audio dubbing mode, Start dubbing, End audio dubbing

Masterpage:Right-NoTitle0
EN
55
Filename [HRS8700EU3.fm]
Page 55
July 20, 2000 4:32 pm
A
Make connections.
Connect an audio component to the AUDIO L + R input
connectors on the recorder’s front panel.
● When connecting a monaural audio component, use only the
recorder’s AUDIO L input connector.
B
Set the recorder’s input mode.
Press AUX (number key “0”) and/or PR to select “F-1” or
“S-1”.
C
Locate the start point.
Press
4
to start playback of the tape in your recorder, and
press
9
when you reach the point where you want to start
dubbing.
D
Engage the Audio Dubbing mode.
Press A.DUB.
● Your recorder enters the Audio Dubbing Pause mode. (“
o
”
blinks, “
u
” and “
i
” light up on the front display panel.)
● To perform Audio Dubbing with audio mixing, press AUDIO
to select “
a
+
s
(L+R)” at this point.
* Audio Dubbing with audio mixing is not possible if you are using a
monaural audio component, or if you don’t have an audio mixer.
E
Start dubbing.
Engage the audio component’s Play mode, then press
4
to start the tape in your recorder; Audio Dubbing begins
at this point.
● “
o
” blinks and “
u
” is displayed on the front display panel.
● To stop dubbing temporarily, press
9
. Press
4
to resume
dubbing.
F
End Audio Dubbing.
Press
8
(or
0
) to stop the tape in your recorder, and
engage the audio component’s Stop mode.
NOTES:
● When monitoring the sound during Audio Dubbing, the
normal soundtrack is automatically selected. If you wish to
hear the mixed sound (Hi-Fi + Normal soundtracks), press
AUDIO to select “
a
+
s
(L+R) + NORM” (
੬
pg. 23).
● Audio Dubbing stops automatically when the counter reaches
“0:00:00”, and the recorder enters the Play mode. Check the
counter reading before dubbing.
● Audio Dubbing is also possible using the rear panel AV1 (L-1)
IN/OUT or AV2 (L-2) IN/DECODER connector. When using
these 21-pin SCART connectors, be sure to select the correct
input mode (“L-1” or “L-2”) in step 2.
● Audio Dubbing is not possible with cassettes whose record
safety tab has been removed.
● When playing back an audio-dubbed tape, press AUDIO to
select the soundtrack you wish to hear. (
੬
pg. 23)
HRS8700EU3.fm Page 55 Thursday, July 20, 2000 4:32 PM