Xj series 1998 user instructions, Scp network – Jaguar XJ User Manual
Page 18
17
DATE OF ISSUE: SEPTEMBER 1997
XJ Series 1998
User Instructions
L
R
CC2( )
LS2R
BT2L
EM2R
(EM1R)
BT2L
Grounds
HARNESS CODE + GROUND EYELET NUMBER + EYELET DESIGNATION (L or R where applicable)
Eyelet designation
Two eyelet variations are used: a single eyelet and an eyelet pair. The single eyelet has a single ‘leg’ and can be identified
by the absence of a suffix. The eyelet pair has two ‘legs’, identified by the suffix L (left) or R (right).
SINGLE EYELET
EYELET PAIR
EXAMPLES:
Harness code
Ground eyelet number
Single leg eyelet
Harness code
Ground eyelet number
RH eyelet leg
Harness code
Ground eyelet number
LH eyelet leg
Where the ground designation differs from LHD to RHD, the RHD ground is shown in parentheses. If the ground designa-
tion is the same for LHD and RHD, only one ground designation is used.
EXAMPLES:
LHD Vehicles
RHD Vehicles
Same for LHD & RHD Vehicles
NOTE: The XJ Series ground studs are not identified by code. Therefore, multiple eyelets with different harness codes
may be connected to a ground stud.
SCP Network
Due to circuit complexity and because space is limited, the SCP Network is, in most cases, shown as a broken grey line
indicating that there is network communication between the depicted control modules. Refer to Fig. 19.1 for circuit details.
EXAMPLE:
S
S
DD10-16
DD10-9
S
U
–
+
S
S
PD10-16
PD10-9
–
+
19.1
19.1
S
U
19.1
19.1
S
U
–
+
19.1
19.1
RD10-9
RD10-16
S
S
S
U
–
+
19.1
19.1
RP10-9
RP10-16
S
S
SCP
SCP
SCP
SCP
SCP
SCP
SCP
SCP
DRIVER DOOR
CONTROL MODULE
PASSENGER DOOR
CONTROL MODULE
DRIVER REAR DOOR
CONTROL MODULE
PASSENGER REAR DOOR
CONTROL MODULE