JVC RC-BF10 - Manual (Page 40)

Troubleshooting
37
Check the following points before having the JVC service center repair this product.
General
CD
Cassette
tape
Radio
Remote
control
Radio Radio
Tape Tape
CD CD
No sound is produced.
The clock display in the
display window is flashing.
Playback does not start.
A certain point on a CD
cannot be played back
properly.
Playing time is displayed,
but no sound is produced.
The sound volume of
playback is low.
Recording does not start
even when you press .
Radio reception is poor
with noise.
You cannot operate the
remote control.
Headphones are
connected.
The main unit is off
because of a power cut.
The power cord is
disconnected (or no
batteries are installed).
The CD is upside-down.
There is condensation on
the lens.
The CD is scratched.
You are trying to play back
an MP3 disc or video CD
(VCD).
The head is dirty.
The write protect tags on
the cassette tape are
snapped off.
The antenna has not been
adjusted to the best
possible position.
The main unit is located
close to a TV, computer,
or other electric appliance.
The remote control
batteries are running low.
The remote control is
exposed to direct sunlight
or other intense light.
Disconnect the headphone
plug.
Reset the clock.
Insert the CD properly,
with the label side facing
up.
Leave the main unit turned
on, wait for several hours
until the moisture has
dried up, and then operate
the main unit.
Replace the CD.
Replace the CD.
Clean the head.
Cover the write protect tag
holes on the cassette tape
with adhesive tape.
Adjust the FM telescopic
antenna (FM). Position the
main unit again for the best
possible reception (AM).
Place the main unit away
from a TV, computer, or
other electric appliance.
Replace the batteries with
new batteries.
Operate the remote
control away from direct
sunlight, fluorescent light.
Problem Possible cause Possible solution Page
10
9
2
20
40
38
39
39
2
15
12
14
7 Measures to Deal with an Irregularity (If this product does not function
properly even after you have implemented the possible solutions given
above)
Many functions of this product are controlled by microcomputers. If the product does not function
properly when you press a button, disconnect the power cord from the AC outlet, wait for a while,
and then connect the power cord again.
RCBF10_25_39.p65 04.8.17, 10:29 36