JVC RC-EX20S - Manual (Page 9)

6
English
SETTING THE CLOCK
PUSH
PLA Y/P AU SE
ST OP
MUTING
HBS/ PRESET EQ
PROGRAM/
CLOCK SET Add"/"
FM MODE
DISPLAY
TA PE
CD
BAND
RANDOM
TUN ER
PRESET
CD REPEA
T
2,3,4 3,4 1
Before operating the unit any further, first set the clock
built in this unit.
The clock uses 12-hour indication. “AM 12:00” indicates
midnight, and “PM 12:00” indicates noon.
1 Press STANDBY/ON to turn off the unit, if it
is turned on.
The clock flashes on the display window.
2 Press and hold PROGRAM/CLOCK SET for more
than 2 seconds.
The hour digits start flashing.
AM
3 Press 4 or ¢ to adjust the hour, then press
PROGRAM/CLOCK SET.
The minute digits start flashing.
PM
4 Press 4 or ¢ to adjust the minutes, then press
PROGRAM/CLOCK SET.
Note:
If there is a power failure, the clock loses the setting and
is reset to “AM 12:00.” The clock indication will keep
flashing until you set the clock again.
To show the clock when CD or tuner is
selected
Press DISPLAY.
Each time you press the button, the display changes the
clock indication and the normal indication alternately.
(Operating the unit while clock indication is displayed
changes the display to the normal indication.)
DISPLAY
02_01-20_RC-EX20SAB_J_En.p65 04.4.21, 2:46 PM 6