JVC RC-EX20S - Manual (Page 14)

11
English
Programmed playback
Up to 20 tracks can be programmed to play in any desired order.
PUSH
PLA Y/P AUSE
ST OP
MUTING
HBS/ PRESET EQ
PROGRAM/
CLOCK SET Add"/"
FM MODE
DISPLAY
TAPE
CD
BAND
RANDOM
TUNER
PRESET
CD REPEA
T
3,5 1 2,4,5 6
Note:
There is a time limit in doing the following steps. If the
setting is canceled before you finish, start from step 2
again.
1 Press CD/RANDOM to enter CD mode.
2 Press PROGRAM/CLOCK SET in stop mode.
The PROG indicator starts blinking in the display
window.
CD
PROG
3 Press 4 or ¢ to select a desired track to be
programmed.
CD
PROG
Track to be programmed
4 Press PROGRAM/CLOCK SET.
5 Repeat steps 3 and 4 to program other tracks.
6 Press PLAY/PAUSE 3/8 while the PROG
indicator blinks.
The tracks are played in the order you have
programmed.
Notes:
• If the PROG indicator goes off before you press PLAY/
PAUSE
3/8, press PROGRAM/CLOCK SET, then
start playback.
• If you press CD/RANDOM while in CD mode, the unit
enters the random playback mode.
To stop during playback
Press STOP
7.
The PROG indicator goes off and the unit exits from
programmed playback.
To check the program contents
Before starting programmed playback, press
PROGRAM/CLOCK SET.
Each time you press the button, the programmed tracks
are shown in the display window.
To add tracks in the program
1 Press PROGRAM/CLOCK SET repeatedly so that
“00” appears as the track number.
2 Press 4 or ¢ to select the track number, then
press PROGRAM/CLOCK SET.
To edit the program
1 Press PROGRAM/CLOCK SET repeatedly so that
the program number you want to edit is shown.
2 Press 4 or ¢ to select a new track number,
then press PROGRAM/CLOCK SET.
To repeat programmed playback
Press PRESET + / CD REPEAT after starting
programmed playback.
To erase the entire program in the memory
Press PROGRAM/CLOCK SET so that the PROG
indicator blinks, and press STOP
7 while the PROG
indicator blinks.
The stored program is also cleared when the disc door is
opened.
Note:
After you have programmed 20 tracks, the program
number returns to “1.” Programming more tracks
overwrite the tracks already programmed to those
numbers.
02_01-20_RC-EX20SAB_J_En.p65 04.4.21, 2:46 PM 11