JBL SCS145.5 - Manual (Page 5)

5
MOUNTING OPTIONS
On shelves.
WALL-MOUNTING
On the wall. Wall
brackets are included.
Slide speaker onto support.
On optional stands (FS1000).
Place speaker and support
on wall plate. Make sure
that at least 1/4" (6mm) of
the wall plate metal shaft is
inserted into the support
cavity. Continue to firmly
press the support onto the
wall plate metal shaft until it
is fully secured in place. Attach plate to wall. The
brackets should be placed, if
possible, so that the screws
will fasten into a wooden wall
stud. If that is not possible,
use properly selected wall
anchors.
The customer is responsible
for proper selection and use
of mounting hardware, avail-
able through hardware stores,
to properly and safely wall-
mount the speakers.
SATELLITES AND SURROUNDS
MOUNTING THE SATELLITES ON OPTIONAL FS1000
FLOOR STANDS
3.
2.
1.
1. Attach the stand adaptor
to the top of the stand
upright with the pins
toward the rear of the
stand. Fasten the adaptor
to the upright with the
supplied screw.
2. Place the loudspeaker
securely on the stand by
inserting the adaptor pin
into the grommet on the
bottom of the speaker.
3. Connect the wire to the
loudspeaker, remember-
ing to preserve the polar-
ity (“+” and “–”) (see
page 6).
IMPORTANT NOTE: The
satellite speaker, when
mounted on these brackets,
can only be adjusted hori-
zontally (left or right). The
speaker cannot be adjusted
vertically (up or down) or
otherwise tilted. Any attempt
to do so will damage the
speaker bracket wall plate
and/or support and such
damage will not be covered
under warranty.
SCS145.5 OM 7/21/04 12:44 PM Page 5