Jeep 50-0283x-019 SERIES - Manual (Page 6)

6
IF VECHICLE IS EQUIPPED WITH A FACTORY 10 DISC CD CHANGER,
PROCEED TO STEP 16.
13. Align top holes in VCP mounting bracket (item 7 pg 2)
with holes in vehicle. See Figure 11.
14. Insert (2) two well nuts (item 2 pg 2) into top holes
and secure using (2) 10-32 x 1" screws (item 3 pg 2)
and (2) two # 10 washers (item 4 pg 2). See Figure 11.
15. Secure bracket to vehicle using (4) four # 10 X 1/2"
screws (item 5 pg 2).
16. Remove and discard storage pocket (item 10
pg 2). Using a razor knife, carefully trim away
plastic flange to allow for CD player. See
Figure 12. Make diagonal cuts at the corners
to make it easier when breaking tabs.
17. Make all necessary wiring connections to VCP.
Check function of VCP. See operating instructions
included with components. For further assistance,
refer to the video system manual for the technical
support phone number listed for your area.
18. Align screws in VCP with slots in bracket and slide
into position. Make sure screws are
positioned at bottom of slot. See Figure 13 .
CAUTION: Do not overtighten screws.
19. Install housing bottom (item 11 pg 2) and carefully
fold carpet away from each side to gain access to
mounting holes. Secure to VCP mounting bracket
using (2) two # 8 X 9/16" screws (item 6 pg 2) on
each side. Make sure contour of housing matches
floor of vehicle. See Figure 14. Carefully tuck carpet
behind O.E. plastic panel.
20. Carefully install housing top (item 9 pg 2) and press
firmly along bottom edge to secure Velcro tape.
FIGURE 11
FIGURE 14
FIGURE 12
FIGURE 13