Jeep 50-0283x-019 SERIES - Manual (Page 3)

3
IF VECHICLE IS NOT EQUIPPED WITH A FACTORY 10 DISC
CD CHANGER, PROCEED TO STEP 5.
1. Locate the O.E.M. CD changer housing
mounted to the rear passenger side of vehicle.
Remove and discard (4) four screws. Remove
and discard housing by moving it upward and
outward. See Figure 1.
2. Disconnect wiring from CD changer.
See Figure 2.
3. Using a 10mm deep socket, remove and retain
(4) four 6mm nuts which secure bracket to
vehicle. See Figure 2.
4. Remove bracket from vehicle. Remove and
retain (6) six screws which secure CD
changer to bracket. See Figure 3. Lay CD
changer in a safe place. Discard bracket.
IF VECHICLE IS EQUIPPED WITH A FACTORY 10 DISC
CD CHANGER, PROCEED TO STEP 6.
FIGURE 1
FIGURE 2
FIGURE 3