Jeep 50-0283x-019 SERIES - Manual (Page 4)

4
5. Locate the O.E.M. storage pocket mounted to
the rear passenger side of vehicle. Remove and
discard pocket by moving it upward and
outward. See figure 4.
6. Using a pin router, razor knife, or suitable tool,
carefully trim plastic panel as shown to allow
clearance for VCP bracket. See Figure 5.
Caution: Before cutting panel, check for
wiring or other componentry behind panel.
Cut only where indicated.
7. Install (2) two housing mounting brackets (item 8 pg 2)
as shown and secure using (3) three # 8 X 9/16"
screws (item 6 pg 2) on each side. See Figure 6.
FIGURE 4
FIGURE 5
FIGURE 6