Presetting stations – JVC MX-KB1 MX-KB2 User Manual

Page 13

Using the Tuner

Eng

lish

Select a station using one of the following
methods.

• Manual Tuning

Briefly press the

22 or ¡ button to move from frequen-

cy to frequency until you find the station you want.

• Auto Tuning

If you hold down the

22 or ¡ button for 1 second or

more and then release it, the frequency changes down, or up,
automatically until a station is found.

• Preset Tuning (Possible only after presetting sta-

tions)
Preset tuning using the Unit:
Select the preset number you want, using the

4 or ¢

button.

Example:

Press the

¢ button until the preset number “8” appears on

the display. The display will show the preset number and
frequency.

Preset tuning using the Remote Control:
Enter the preset number you want to recall using the numer-
ic keys. See “Entering the Number with the Remote Con-
trol” on page 8.

Example:

Press 8 to recall the preset number 8. Then, the display will
show the preset number and frequency.

• In AM broadcast, reception sensitivity will be chang-ed by

turning the AM loop antenna. Turn the AM loop antenna for
best reception.

Presetting Stations

You can preset up to 10 FM stations and up to 10 AM stations.

• Preset numbers may have been set to factory test fre-

quencies prior to shipment. This is not a malfunction. You
can preset the stations you want into memory by following
one of the presetting methods below.

• During presetting stations, if no button operation is made

for 4 seconds, the display returns to the band/frequency
display. In this case, repeat steps from the beginning.

Using the Unit

Select a band by pressing the FM/AM button.

Press the

button to tune in a

station.

Press the SET button.

“00” will blink for 4 seconds.

Press the

button to select the

preset number.

¢:

Increases the preset number by 1.

4: Decreases the preset number by 1.

Press the SET button.

The display shows the stored preset number and frequency.

Repeat above steps 2 to 5 for each station
you want to store in memory with a preset
number.

To change the preset stations, repeat the same steps as
above.

• In step 4, you can select the preset number using the nu-

meric keys on the Remote Control. See “Entering the
Number with the Remote Control” on page 8.

CAUTION:

• Even if the System is unplugged or if the power

failure occurs, the preset stations will be stored
for a few days. However, in case the preset sta-
tions are erased, you will need to preset the sta-
tions again.

To Change the FM Reception
Mode

When you are tuned in to an FM stereo broadcast, the “ST (Ster-
eo)” indicator lights up and you can hear stereo effects.
If an FM stereo broadcast is hard to receive or noisy, you can select
Monaural mode. Reception improves, but you lose stereo effect.

Press the FM MODE button on the Remote Control so
that the “MONO” indicator lights up on the display.

To restore the stereo effect, press the FM MODE button on
the Remote Control so that the “MONO” indicator goes off.
Selecting other station will also cancel the FM Mono mode and re-
store the stereo effect.

SET

FM=10, AM=10

SET

When changing the Band

MONO

MX-KB2[UW].book Page 10 Friday, May 14, 2004 5:46 PM