JVC AV 20F476 - Manual (Page 31)

31
Channel guard and V-Chip settings are protected by a four-digit lock code. Your TV comes
preset with a lock code of “0000”. You may change the code to any four-digit number you wish.
To change the lock code, follow the steps below.
Press the M ENU button
π† To SET LOCK CODE
è To operate (lock icon appears)
Press Z ERO to access the lock code
The first digit will be highlighted
è To select the number
π† To move to the next digit
Continue to follow these directions for all four numbers
π† To FINISH
è To save settings and exit
(your lock code is now set)
Press the E XIT button when finished
• After a power interruption you must reset the lock code.
• Write your lock code number down and keep it hidden from potential viewers.
• If you forget the lock code, a new code may be set using the steps listed above.
Notes:
When a viewer attempts to watch a blocked channel, this message appears:
The channel will remain blocked until the correct lock code is entered (see above for
information on setting your lock code).
Initial Setup
Set Lock Code
I N I T I A L S E T U P >
S E T L O C K C O D E
F I N I S H
S E L E C T B Y
O P E R A T E B Y E X I T B Y E X I T
L O C K C O D E 0 0 0 0
THIS PROGRAMMING EXCEEDS
YOUR RATING LIMITS.
PLEASE ENTER LOCK CODE BY
10 KEY PAD TO UNLOCK IT.
NO. - - - -
LCT1785-001A-A ENG 31 12/16/04, 2:38:42 PM