Juniper Networks EX2500 - Manual (Page 72)

EX2500 Ethernet Switch Configuration Guide
58 „ Using ACL Filters
When you assign an ACL to a port, the ACL acts only upon ingress traffic, not egress
traffic.
To assign an ACL to a port:
ex2500(config)# interface port 1
ex2500(config-if)# ip access-group 128 in
ex2500(config-if)# exit
To delete an ACL from a port:
ex2500(config)# interface port 1
ex2500(config-if)# no ip access-group 128 in
ex2500(config-if)# exit
Viewing ACL Statistics
ACL statistics display how many packets hit (matched) each ACL. Use ACL statistics
to check filter performance, and debug the ACL filters. You must enable statistics
for each ACL that you want to monitor. Use the following command to enable
statistics for the ACL:
ex2500(config)# access-list ip standard 128 statistics
Use the following command to view ACL statistics:
ex2500(config)# show access-list counters
Configuring ACL Port Mirroring
To filter packets for monitoring or analysis, you can apply an ACL filter to mirror
packets that match the ACL. Packets that match the ACL filter are copied and
forwarded to a physical interface port.
The port receiving the mirrored packets must be a physical port and not a static
trunk group (portchannel), which is a virtual link, but the port can be a member of a
trunk group.
A port that has an ACL applied to it cannot receive packets filtered by its own ACL.
You can configure IP standard and extended ACLs and MAC extended ACLs for port
mirroring. For example, use the following command to configure an IP standard
ACL port mirror:
ex2500(config)# access-list ip standard 128 port mirror
For more information about port mirroring, see “Monitoring Ports with Port
Mirroring” on page 85.
ACL Configuration Examples
ACL Example 1—Blocking Traffic to a Host
Use this configuration to block traffic to a specific host. All traffic that ingresses
port 1 is denied if it is destined for the host at IP address
100.10.1.1.