beautypg.com

Mp6610, Preparation (continued), Wiring – Jensen MP6610 User Manual

Page 3: Install half-sleeve, Fuses, Reconnect battery

background image

MP6610

3

Jensen Connector

1

2

4

1

2

3

White/Black (-)

Blanco/Negro (-)

Blanc/Noir (-)

White / Blanco / Blanc (+)

Gray/Black (-)

Gris / Negro (-)

Gris / Noir (-)

Gray / Gris / Gris (+)

Violet / Violeta / Violet (+)

+

10A

1

2

3

4

5

7

6

8

Green / Verde / Vert (+)

Green/Black (-)
Verde/Negro (-)

Vert/Noir (-)

Violet/Black (-)

Violeta/Negro (-)

Violet/Noir (-)

Black

Negro / Noir

Gray

Gris / Gris

Front
Frente
Avant

Rear

Posterior

Arrière

9

10

11

12

Preparation (continued)

Install Half-Sleeve

1.

Install adapter and dash kit if necessary (optional).

2.

Install half-sleeve into adapter or dashboard.

3.

Push tabs out to secure half-sleeve in the radio opening.

4.

Install support strap to make unit more stable.

Wiring

Wiring with a Wiring Adapter (Purchased Separately)

Connect Wires

You can make all these connections without even being in the car.

1.

Splice or crimp wires.

2.

Attach wiring adapter to car wiring harness.

Wiring Diagram / Color Codes

1.

Power Antenna (dark blue wire) – Connect to power antenna or amplifier. If not used, tape
bare end of wire.

2.

Ground (black wire) – Connect to ground terminal or clean, unpainted part of chassis.

3.

Memory/Battery (yellow wire) – Connect to battery or 12 volt power source that is always
alive. The radio will not work if this wire is not connected.

4.

Accessory/Ignition (red wire) – Connect to existing radio wire or radio fuse.

5.

Left front speaker

6.

Right front speaker

7.

Left rear spearker

8.

Right rear speaker

9.

RCA Outputs to Amplifier

10. Auxiliary Input Cable (yellow)

11.

Antenna

12. CD Changer

Fuses

When replacing a fuse, make sure the new fuse is the correct type and amperage. Using an
incorrect fuse could damage radio. The MP6610 uses one 15 amp fuse located below the
wiring connector: 15 amp fast blow ATO.

Reconnect Battery

When wiring is complete, reconnect the battery negative terminal.

Install Half-Sleeve

Instalación de la Camisa

Installation du Demi-Manchon

Connect Wires

Conecte los Cables

Raccordement des Fils

Wiring

Cableado

Câblage