Jet Tools JWBS-18X - Manual (Page 14)

14
Adjustments
Table Tilt
1. Disconnect machine from power source.
2. Loosen the lock knobs (G, Fig. 14).
3. Tilt table up to 45 degrees to the right, or up to
10 degrees to the left.
4. Tighten the lock knobs.
Note: Table stop bolt (F, Fig. 14) must be removed
to tilt table to the left.
Adjusting 90 Degree Table Stop
Blade tension must be properly adjusted prior to
adjusting 90 degree stop. Refer to the Adjusting
Blade Tension section.
1. Loosen lock knobs (C, Fig. 15) and tilt the table
until it rests against table stop bolt (B, Fig. 15);
then re-tighten the lock knobs.
2. Use a square (E, Fig. 16) placed on the table
and against the blade to see if the table is 90
degrees to the blade.
3. If an adjustment is necessary, loosen the lock
knobs (C, Fig. 15). Tilt the table until it is
square to the blade; then re-tighten the lock
knobs.
4. Loosen lock nut (A, Fig. 15) and turn table stop
bolt (B, Fig. 15) until it contacts the table.
Tighten the nut (A, Fig. 15) to hold table stop in
place. When tightening the nut hold the table
stop bolt in place with a wrench to prevent
movement.
5. If necessary, adjust the pointer (D, Fig. 15) to
zero.
Figure 14
Figure 15
Figure 16