JVC CA-MXG51R - Manual (Page 21)

– 18 –
Recording
Recording a Tape on Deck B
On the unit ONLY:
1
Press EJECT
0 for the deck B.
2
Put a recordable cassette in with the exposed
part of the tape down.
3
Close the cassette holder gently.
4
Start playing the source — FM, MW, LW,
CD player or auxiliary equipment connected
to AUX IN jacks.
• When you want to use the dubbing method, see
“Dubbing Tapes” on page 19.
• When the source is CD, you can also use CD Synchro
Recording (see “CD Synchro Recording” on page 19.)
5
Press REC START/STOP.
The REC (recording) indicator lights up on
the display and recording starts.
To stop during recording, press REC START/STOP again
or
7.
To remove the cassette, press EJECT
0 for deck B.
IMPORTANT:
• It should be noted that it may be unlawful to re-record
pre-recorded tapes, records, or discs without the
consent of the owner of copyright in the sound or video
recording, broadcast or cable programme and in any
literary, dramatic, musical, or artistic embodied
therein.
• The recording level is automatically set correctly, so it is
not affected by the VOLUME control, the SOUND MODE
control and the SUBWOOFER LEVEL control. Thus,
during recording you can adjust the sound you are actually
listening to without affecting the recording level.
• While recording, you can hear sound modes through the
speakers or headphones. However, the sound is recorded
without these effects (see page 10).
• If recordings you have made have excessive noise or static,
the unit may be too close to a TV. Place the unit away from
the TV.
• You can use type I tape for recording.
To protect your recording
Cassettes have two small tabs
on the back to protect
unexpected erasure or re-
recording.
To protect your recording,
remove these tabs.
To re-record on a protected tape, cover the holes with
adhesive tape.
To keep the best recording and playback sound quality
If the heads, capstans, and pinch rollers of the cassette decks
become dirty, the following will occur:
• Impaired sound quality
• Discontinuous sound
• Fading
• Incomplete erasure
• Difficulty in recording
To clean the head, capstan, and pinch roller
Use a cotton swab moistened with alcohol.
To demagnetize the head
Turn off the unit, and use a head demagnetizer (available at
electronics and audio shops).
Head
Capstan
Pinch roller
EJECT
EJECT
Erase head
REC START
/STOP
CD
REC
Continued
EN18-26.CA-MXG51R[B]_f 01.2.15, 8:53 PM 18