JBL CONTROL NOW User Manual

Page 22

2-CHANNEL WIRING FOR EVEN
SOUND DISTRIBUTION

1. Use the even sound distribution connection for even sound distribution through

both channels. Run the sets of paired wires out two wire access holes
through the pole-mount bracket, as shown.

NOTE: This procedure is applicable for both large- and small-diameter
drop tubes. A large-diameter drop tube is shown here.

2-Channel-wiring for even sound distribution.

2. Remove the terminal assemblies from the rear of all speakers. The terminal

assembly is removed by rotating it slightly counterclockwise, as shown.

Use the transparent plastic strap to pull the terminal assembly out, as shown.

3. Connect the small end of the multiunit wiring adapter to the rear of speakers

A and B, as shown.

4. Place speakers A and B with connectors attached on the pole-mount bracket,

as shown. Run the wiring for the multiunit wiring adapter through the wire
access holes, as shown.

5. Slide the large end of the multiunit wiring adapter that is already attached

to speaker A into the rear of speaker C at a slight angle and rotate clockwise,
as shown.

6. Connect the terminal assembly to the back of the multiunit wiring adapter,

as shown. It will snap securely into place.

This end is connected to speaker A.

This end is connected to speaker

Pole-Mount-Bracket Cap

Drop Tube

Pole-Mount

Bracket

Wire Access

Holes

Connector

Multiunit Wiring Adapter
to connect to speaker

Pole-Mount-

Bracket Cap

Drop Tube

Pole-Mount

Bracket

Wire Access Holes

JBLP2605_CN_CNAW_PM-OM 4/23/08 12:57 PM Page 22