JVC TM-H1700G - Manual (Page 11)

HOW TO USE THE MENU
FUNCTIONS
(cont’d)
10
EXIT
CHROMA MENU
PHASE BRIGHT
CONTRAST VOLUME/SELECT
DISPLAY AND SELECTIONS IN THE MENU> MODE (SETTING)
• PICTURE SUB ADJ. • WHITE BALANCE • REMOTE SYSTEM
• H. POSITION • CONTROL LOCK • INPUT REMOTE
• V. POSITION • STATUS DISPLAY
You can set the following set-up menu items.
1. While pressing the MENU button, press the
CHROMA/PHASE button.
The screen is displayed.
2. Press the CHROMA/PHASE or CONTRAST/BRIGHT
button to select the desired menu item.
A selection mark (4) is put next to the selected item.
3. Press the VOLUME/SELECT buttons to set.
● For WHITE BALANCE items, select the CUT OFF or DRIVE
setting screen, then select the function display for adjustment.
● Press the EXIT (MENU) button to return to the
MENU> screen.
Notes:
screen
1 Selection mark (4): Indicates the
menu item you select.
2 Menu item: Menu items you can
select.
3 Setting display: Indicates the
current settings (value).
4 Function display: The functions of
the front panel buttons (5 buttons
on the left) correspond to the
function displayed.
Function
Contents
displayed
ᮢ Forward the menu item.
ᮡ Reverse the menu item.
– Lower the adjustment
value. (to the minimum)
+ Raise the adjustment
value. (to the maximum)
4 Forward the setting value.
1 Reverse the setting value.
EXIT
Exit the
DRV Selects DRIVE adjustment.
CUTO
Selects CUT OFF
adjustment.
RB
Adjusts red and blue
signal level.
RGB
Adjusts red, green and
blue signal level.
Turns the ON-SCREEN
display on or off. (This
DISP function is effective only
in the DRIVE or CUT OFF
adjustment mode.)
Front panel Function
Contents
button displayed
CHROMA/
ᮢ Forward selection mark ( 4 )
PHASE
CONTRAST/
ᮡ Reverse selection mark ( 4 )
BRIGHT
Front panel Function
Contents
button displayed
+ Increase (to max. value)
4 Forward the setting value
CUTO Selects CUT OFF setting screen
– Decrease (to min. value)
1 Reverse the setting value
DRV Selects DRIVE setting screen
VOLUME/
SELECT (–)
VOLUME/
SELECT (+)
● Parameters for PICTURE SUB ADJ., H. POSITION and V. POSITION can be set
separately depending on the signal (Input A (VIDEO), Input B (VIDEO) or Input B (Y/
C)) selected with the input select buttons on the front panel.
Select the required video input with the input select buttons on the front panel in
advance.
● WHITE BALANCE can be set independently at 6500 or 9300 for the color temperature
value.
Set COLOR TEMP. to 6500 or 9300 on the
● INPUT REMOTE is shown when REMOTE SYSTEM is set to MAKE.
Notes:
4 PICTURE SUB ADJ.
H. POSITION
: 00
V. POSITION : 00
WHITE BALANCE
CONTROL LOCK
: OFF
STATUS DISPLAY : ON
REMOTE SYSTEM : MAKE
INPUT REMOTE : A – B
1
2 3
4
PICTURE SUB ADJ.
H. POSITION
V. POSITION
WHITE BALANCE
CONTROL LOCK
STATUS DISPLAY
REMOTE SYSTEM
INPUT REMOTE
MENU CHROMA
PHASE
CHROMA
PHASE BRIGHT
CONTRAST
VOLUME/SELECT
LCT1092-002A-H(EN) 02.4.25, 9:48 AM 12