Troubleshooting, Power video and d.s.c. playback – JVC LYT1300-001A User Manual
Page 43
EN
43
Master Page: Right-Heading0
TROUBLESHOOTING
If, after following the steps in the chart below, the problem still exists, please consult your nearest JVC dealer.
Power
Video and D.S.C. Playback
The player is a microcomputer-controlled device. External noise and interference (from a TV, a radio, etc.)
might prevent it from functioning properly. In such cases, first disconnect its power supply unit (battery pack,
AC Power Adapter/Charger, etc.) and wait a few minutes; and then re-connect it and proceed as usual from
the beginning.
SYMPTOM
POSSIBLE CAUSES
CORRECTIVE ACTION
1. No power is supplied.
1. • The power is not connected
properly.
• The battery is dead.
1. • Connect the AC Power
Adapter/Charger securely.
(
• Replace the dead battery
with a fully charged one.
(
SYMPTOM
POSSIBLE CAUSES
CORRECTIVE ACTION
2. Play, Rewind and Fast-Forward
functions do not work.
2. • The Playback Mode Switch is
set to “MEMORY”.
2. • Set the Playback Mode
Switch to “VIDEO”.
3. The tape is moving, but there is
no picture.
3. • Your TV has AV input
terminals, but is not set to its
VIDEO mode.
• The cassette holder cover is
open.
3. • Set the TV to the mode or
channel appropriate for
video playback. (
• Close the cassette holder
cover. (
4. Blocks of noise appear during
playback, or there is no
playback picture and the
screen becomes blue.
4. •
—
• The tape is recorded in LP
mode.
4. • Clean the video heads with
an optional cleaning
cassette.
• This is not a malfunction.
5. A memory card cannot be
played back.
5. • The Playback Mode Switch is
set to “VIDEO”.
5. • Set the Playback Mode
Switch to “MEMORY”.
6. The image on the 4:3 TV is
elongated vertically (squeeze).
6. • This occurs during recording
in HD or SD mode when a
tape (its erase protection tab
is set to “REC”) is loaded.
• The component video cable
and S-video or audio/video
cable are connected
simultaneously.
6. • This is not a malfunction.
• Disconnect either of two
cables.
7. The screen of the LCD monitor
is blackened or blocks of noise
appear on its right side but 4/
9 is not pressed.
7. • The S-Video or audio/video
cable is connected and “S/AV
INPUT” (
੬ pg. 27) is set to
“ON”.
7. • This is not a malfunction.
After dubbing, set “S/AV
INPUT” back to “OFF”.
8. When the screen is under
direct sunlight, the screen
becomes red or black for an
instant.
8. • This is not a malfunction.
8.
—
CU-VH1E.book Page 43 Friday, March 26, 2004 1:55 PM