JVC AV-14F703 - Manual (Page 7)

7
BATTERY PRECAUTIONS
The precautions below should be followed when using
batteries in this device:
1. Use only the size and type of batteries specified.
2. Be sure to follow the correct polarity when installing
the batteries as indicated in the battery compartment.
Reversed batteries may cause damage to the device.
To avoid a potential short circuit, insert the “–” end
first.
3. Do not mix different types of batteries together (e.g.
Alkaline and Carbon-zinc) or old batteries with fresh
ones.
4. If the device is not to be used for a long period of time,
remove the batteries to prevent damage or injury from
possible battery leakage.
5. Do not try to recharge batteries not intended to be
recharged; they can overheat and rupture. (Follow
battery manufacturer’s directions.)
6. When you change the batteries, try to complete the
task within three minutes. If you take longer than three
minutes, the remote control codes for your Cable Box
may have to be reset (see page 8).
EFFECTIVE DISTANCE OF THE REMOTE
CONTROL TRANSMITTER
15 FEET
30˚ 30˚
NOTES: • When there is an obstacle between the TV
and the transmitter, the transmitter may not
operate.
• When direct sunlight, an incandescent lamp,
fluorescent lamp or any other strong light
shines on the Remote sensor of the TV, the
remote operation may be unstable.
CHANGING THE BATTERIES
Push down on the remote’s back cover and slide
towards the bottom to remove it.
Insert two AA batteries (supplied), carefully noting the
“+” and “–” markings on the batteries and on the remote
control. To avoid a potential short circuit, insert the “–”
end first.
Be sure to use only size AA batteries.
When batteries are installed, slide the cover back into
place (until it clicks into position).
• If the remote control acts erratically, replace the
batteries. Typical battery life is six months to one year.
We recommend using alkaline batteries for longer
battery life.
When you change the batteries, try to complete the
task within three minutes. If you take longer than three
minutes, the remote control codes for your VCR, DVD,
and/or Cable Box may have to be reset (pages 8-10).
• Before you can operate the remote control, you must
first install the batteries (included). See “Changing the
Batteries” on this page above for instructions. (For an
illustration, please see page 6.)
• Press the POWER button to turn the television on or
off.
• Make sure the TV/CATV switch is set to TV. Move the
switch to
CATV only if you need to operate a cable box.
• Slide the VCR/DVD selector switch to VCR to control
a VCR, slide to DVD to control a DVD player. Please
see pages 8 to 10 for instructions on programming
your remote control to operate a Cable box, VCR or
DVD player.
• Press the CH + and CH – buttons to scan through the
channels. Tap the CH + or CH – button to move
through the channels one channel at a time.
• Press VOL + or VOL – to raise or lower the volume.
An indicator bar will appear onscreen to show you the
television volume level.
• The CH +/– and VOL +/– buttons are also used to
navigate JVC’s onscreen menu system.
• You can directly access specific channels using the
10-key pad.
• This remote includes illuminated buttons for key
features like CH +/– buttons, and VOL +/– buttons.
Press the LIGHT button to turn the illumination on.
REMOTE CONTROL BASICS
3L00501A E/01-13 1/4/2002, 8:17 7