JVC UX-P400 - Manual (Page 14)

12
Changing the Display Brightness
You can dim the display window.
Setting the Clock
Without setting the built-in clock, you cannot use Daily/
Recording Timers (see page 21) and Sleep Timer.
• To exit from the clock setting, press CLOCK/TIMER as
required.
• To go back to the previous step, press CANCEL.
1
Activate the clock setting mode.
• If you have already adjusted the clock before, press the
button repeatedly until the clock setting mode is
selected.
2 Adjust the hour.
3 Adjust the minute.
Now the built-in clock starts working.
To check the current time during play
Turning Off the Power
Automatically
To turn off the unit after playback is over—Auto
Standby
When Auto Standby is in use, the A.STANDBY indicator
lights on the display.
When the tape or disc play stops, the A.STANDBY indicator
starts flashing. If no operation is done for about 3 minutes
while the indicator is flashing, the System turns off (stands
by) automatically.
• Auto Standby does not work while you are listening to
radio and the external component (AUX).
To turn off the unit after a certain period of time
—Sleep Timer
1 Specify the time (in minutes).
2 Wait until the set time goes off.
To check the time remaining until the shut-off time
• If you press the button repeatedly, you can change the shut-
off time.
DIM 1 Dims the display.
DIM 2 Erases the display illumination.
Remote
ONLY
DIMMER DIM 1 DIM 2
DIM OFF
(Canceled)
Remote
ONLY
CLOCK/
TIMER
SET
SET
DISPLAY Clock
Source information
Remote
ONLY
A.STANDBY ON OFF
(Canceled)
SLEEP 10 20 30 60 90 120
Canceled
150
SLEEP
SLEEP
Basic.fm Page 12 Sunday, January 18, 2004 6:56 PM