JVC RX-772VBK - Manual (Page 14)

Page 11
AUDIO/TV
/VCR
CATV
/SAT
STANDBY
POWER
Basic Operations
The following operations are commonly used when you play any sound source.
IMPORTANT
When using the Remote Control, check to see if its remote control mode selector is set to the
correct position:
To operate an audio system, TV, and VCR, set it to the “AUDIO/TV/VCR” position.
To operate a CATV converter and satellite tuner, set it to the “CATV/SAT” position.
Turning the Power On and Off
On the front panel:
To turn on the power, press POWER.
The STANDBY lamp goes off. The name of the current source (or station frequency) appears on the
display.
To turn off the power, press POWER again.
The STANDBY lamp lights up.
From the remote control:
To turn on the power, press AUDIO POWER.
The STANDBY lamp goes off. The name of the current source appears on the display.
To turn off the power, press AUDIO POWER again.
The STANDBY lamp lights up.
Selecting the Source to Play
You need to select the source before you start playing any source.
On the front panel:
1. Press SOURCE so that the Control % % % % % / fi fi fi fi fi buttons work for selecting the source.
2. Press Control % % % % % / fi fi fi fi fi until the source name you want appears on the display.
The selected source lamp also lights up.
Front panel
STANDBY
POWER
Current source
name appears
Volume level is also
shown here
whenever the power
is on.
AUDIO
POWER
VOLUME 100 1k 10k
Remote Control
SOURCE
Front panel
MENU
See also
page 31.
Selected source
name appears
MUTE AUTO TUNED STEREO
SURROUND PRO LOGIC LOGIC 3CH HALL
SEA LOUDNESS
VOLUME VISUAL CONFIRMATION
CH–
MHz
kHz
FM
AM
SLEEP
100 1k 10k
RX-772VBK[J]_0052-001A.En.01-23 97.4.8, 3:23 PM 11