JVC RX-772VBK User Manual

Page 33

Page 30

Using Dolby Surround

Once you have set the Dolby Surround adjustments you can use the same adjustments every time you want
to enjoy Dolby Surround.
The receiver memorizes two sets of Dolby Surround adjustments; one for Pro Logic and the other for 3ch
Logic.

On the front panel:

1. Press SURROUND MODE so that the Control

% / fi

fi buttons work for selecting the surround

modes.
The lamp next to the button lights up.

2. Press Control

% / fi

fi until “PROLOGIC” or “3CHLOGIC” whichever you want appears on the

display.
The PRO LOGIC or 3CH LOGIC indicator (as well as the SURROUND indicator) also lights up.
Each time you press the button, the surround modes change as follows (the indicator of the selected
surround mode also lights up on the display):

3. Select and play a sound source which was processed with Dolby Surround and is labeled with

DOLBY SURROUND

mark.

To cancel Dolby Surround, press Control

% / fi until “SURR OFF” appears in step 2 above. The indicator

of the selected mode and the SURROUND indicator go off.

From the remote control:

1. Press SOUND CONTROL.

The remote control is activated for adjusting the sound.

2. If necessary, press SURR MODE until “PROLOGIC” or “3CHLOGIC” whichever you want

appears on the display.
The PRO LOGIC or 3CH LOGIC indicator (as well as the SURROUND indicator) also lights up.
Each time you press the button, the surround modes change as follows (the indicator of the selected
surround mode also lights up on the display):

3. Select and play a sound source which was processed with Dolby Surround and is labeled with

DOLBY SURROUND

mark.

To cancel Dolby Surround, press SURR MODE until “SURR OFF” appears in step 2 above. The
indicator of the selected mode and the SURROUND indicator go off.

SURROUND MODE

SOUND

CONTROL

+10

SURR MODE

100+

Remote Control

Front Panel