JVC UX-H30 - Manual (Page 41)

8
English
Speaker grille
To remove the speaker grille, insert your fingers at
the top of the speaker grille, pull towards you. Then
pull the bottom towards you.
To attach the speaker grille, follow the illustration
above.
Connecting Other Equipment
To connect an audio equipment
You can connect audio equipment—used only as a
playback device.
• DO NOT connect any equipment while
the power is on.
• DO NOT plug in any equipment until all
connections are complete.
Be sure that the plugs of the audio cords are colored:
White plugs and jacks are for left audio signals, and
red ones for right audio signals.
Holes
Projections
To remove the speaker grilles
The speaker grilles are removable.
L
R
L
R
To audio output
Audio equipment
Adjusting the Voltage Selector
Before plugging in the unit, set the correct voltage for
your area with the voltage selector on the rear of the
unit.
Use a screwdriver to rotate the voltage selector so the
voltage number the voltage mark is pointing at is the
same as the voltage where you are plugging in the unit.
(See the back cover page.)
DO NOT plug in before setting the voltage
selector on the rear of the unit and all
connection procedures are complete.
NOW you are ready to plug in the unit
and any other connected equipment.
IMPORTANT: Be sure to check all connections to
be done before plugging the power cord.
This unit can be supplied with power through the AC
IN connector (at home) or the DC IN connector (in a
car).
• Do not connect the unit using the AC IN connector
and the DC IN connector at the same time for safe
and correct use.
To connect the AC power cord
Connect the AC power cord to the AC IN connector
and a wall outlet.
• If the wall outlet does not match the AC plug, use
the supplied AC plug adaptor.
Continued
For playing other equipment through this unit,
connect between the audio output jacks on the other
equipment and AUX jacks by using audio cords (not
supplied).
A C I N
AC power cord (supplied)
2 3 0 V
V O L T A G E
S E L E C T O R
1 2 7 V
1 1 0 V
Voltage mark
EN01-13_UX-H30[UW]f.pm6 03.3.12, 3:38 PM 8