GE 99003 GE Bluetooth Advanced Stereo Headphone - Manual (Page 5)

5
Volume Control
Press or hold the Volume Up or Volume Down button to adjust.
You will hear a clicking sound when you adjust the volume to the
maximum or minimum sound level.
Power ON / Standby mode
Press and hold the power button for 3 seconds.
• The Blue LED will blink rapidly: 3 times in 2 seconds
• The standby mode allows the transmitter (phone, USB adapter,
etc.) to automatically connect with the 99003 headset if the
initial pairing has already been done. Please refer to the
following section on “Pairing Mode” if this is a fi rst time pairing
of the two devices.
Caution: You will hear a high-pitched tone when the headphones
are turned ON (press the power button for 3 seconds) and the
headphones enter standby mode. If you keep pressing the power
button for another 3 seconds then Bluetooth
® discovery/pairing
is initiated. You may want to wait until after the tone stops before
wearing the headphones
Function/ Button Button Button Button Button Button
Mode 1 2 3 4 5 6
Volume Volume Play / Next Previous Power Pairing
Up: Down: Pause: Track: Track: On/Off Press & Hold
Audio Press Press Short Short Short Press 6 Sec.
& Hold & Hold Press Press Press & Hold
Volume Volume Answer Power Pairing
Phone Up: Down: Phone: On/Off Press & Hold
Press Press Long Press 6 Sec.
& Hold & Hold Press & Hold
Short Press: < 3 seconds
Long Press: > 3 seconds
Button Functions
Note: To conserve battery power, always remember to turn off
the GE 99003 headphones when not in use.