Pin assignment, Cv-m10bx/cv-m10rs – JAI CV-M10 User Manual
Page 6
CV-M10BX/CV-M10RS
- 3 -
5. Pin Assignment
5-1. 12-pin Multi-connector (DC-IN/SYNC.)
Type: HR10A-10R-12PB-01 (Hirose) male seen from rear.
!
"
#
$
%
&
'
Notes: *1) Signals on pin no. 6, 7 and 9 can be changed by jumper setting.
See "8. Jumper Settings" for more information.
*2) In Edge Pre-select and Pulse Width Control mode do not input ext. VD signal.
5.2. 6-pin Multi-connector (RS 232C/TRIGGER)
Type: HR10A-7R-6PB (Hirose) male seen from rear.
Note: WEN is generated in Normal Trig, Random Trig (normal and high speed
shutter) and Low Speed Shutter. It is 1 H long and indicates the beginning
of video read out.
Pin no.
Signal
Remarks
1
GND
2
+12 VDC input
3
GND
4
Video 1 output
Parallel with the BNC video 1 output. Avoid double termination.
5
GND
6
HD input/output
Ext. HD in as factory setting. *1)
7
VD input/output
Ext. VD in as factory setting. *1) *2)
8
GND
9
Video 2 output
Video 2 only in 2:1 interlace. Pixel clock output. Opt. *1)
10
GND
11
+12 V DC input
12
GND
Pin no.
Signal
Remarks
1
TXD out
NC on BX version
2
RXD in
NC on BX version
3
GND
4
NC
5
Ext. Trig input
6
WEN output
* Note
! "
#
$