JAI CV-M10 - Manual (Page 14)

CV-M10BX/CV-M10RS
- 11 -
8. Jumper settings
Switch off the power before making any mode or jumper settings.
The following modes are available with jumper setting:
Input/Output Mode of HD/VD signal. (HD/VD input is factory setting)
Termination of HD/VD input. (75 ohm is factory setting.)
Trigger input termination. (Factory setting is TTL)
Trigger mode select. (Edge Pre-select is factory setting)
H-reset or H non-reset. (Fatory setting is H reset.)
Alternative pins for inputs/outputs.
Jumper settings in "italic bold" are factory setting.
8.1. HD/VD signals
Jumpers on PK8189A.
8.2. Trigger input termination
Jumper on PK8206A for BX or PK8190A for RS.
8.3. Trigger mode selection
Jumpers on PK8206A for BX or PK8190A for RS.
8.4. Pixel clock or video 2 on pin 9 (12 pin con.)
Jumpers on PK8187A.
*) Note: For Pulse Width Control, shutter speed must be set to 1/10,000 sec. (For BX by SW1. For RS by RS232C)
Jumper Function
HV and VD signals
Remarks
Input 75 ohm Input TTL Output
JP 1 Ext. HD input Short Short Open
JP 3 Ext. HD input 75 ohm term. Short Open Open
JP 7 Int. HD output Open Open Short
JP 4 Ext. VD input Short Short Open
JP 6 Ext. VD input 75 ohm term. Short Open Open
JP 5 Int. VD output Open Open Short
Jumper Function
Trigger input
Remarks
TTL input 75 ohm terminated
JP10 Trigger input termination Open Short
Jumper Function
Random Trigger Shutter Mode
Remarks Edge Pre-select Pulse Width Control *)
H-reset H non-reset H reset H non-rest
JP 12 Trigger mode select Open Open Short Short
JP 13 H reset/non-reset Open Short Open Short
8.5. Alternative input/outputs on pin #6 and #7 (12 pin con.)
Jumpers on PK8187A.
Jumper Function
Signal on Pin 9 (12 pin con.)
Remarks
Video 2 Pixel clock
R 19 Pixel clock out on pin #9 Open Short
R 20 Video 2 out on pin #9 Short Open
Jumper Function
Signal on pin #6 Signal on pin #7
Remarks
HD in/out Trigger in VD in/out Trigger in WEN out
R 21 WEN - - Open Open Short
R 26 Trigger Open Short - - -
R 27 Trigger - - Open Short Open