Jacuzzi J - 230 - Manual (Page 34)

J-200 Series
lock modes (l1-l2)
l1 Lock Out (disables all spa functions to permit filter
cleaning)
l2 Lock Mode (disables the jets and light buttons to
prevent unauthorized use of spa). Filtration/heating
cycle will continue to operate as programmed in
this mode. The temperature display flashes when this function is
enabled. Example: the “F3” filtration/heating cycle was enabled
prior to choosing lock mode. The spa continues to perform the
“F3” cycle until lock mode is canceled, allowing another cycle to be
selected.
To set a time for the first filtration/heating cycle, simply turn power on to
the spa two minutes prior to the desired time. Example: If you desire your
first filtration/heating cycle to begin at 10:00 AM turn off power to the spa
and turn it back on again at 9:58 AM.
note: Start time is approximate and may vary slightly from day to day.
11.7 Filtration modes for spas with Circulation pump option
(J-230, J-270 and J-280 only)
If your spa is not equipped with the circulation pump option, disregard
this section and refer to page 29 for filter cycle programming details.
standard Filtration/heating Modes (F0-F3)
(Heater automatically turns on during any heat call while in any Standard
mode).
F0 5 minutes of filtration per day (one 5 minute “Blow-Out”
cycle every 24 hours to purge all plumbing lines)
F1 1 hour of filtration per day (one 30-minute cycle every
twelve hours); this is the factory default setting.
F2 1.5 hours of filtration per day (one 30-minute cycle
every eight hours).
F3 2 hours of filtration per day (one 30-minute cycle every
six hours).
economy Filtration/heating Modes (F4-F6)
(Heater can only turn on during an active filter cycle while in any
economy mode).
F4 1 hour of filtration/heating per day (one 30-minute
cycle every twelve hours).
F5 1.5 hours of filtration/heating per day (one 30-minute
cycle every eight hours).
F6 2 hours of filtration/heating per day (one 30-minute
cycle every six hours).
30