JVC SX-WD10 - Manual (Page 4)

Warnings, Cautions and Others Preparation
Precautions for installation
Do not install the speakers on an uneven surface or in a place
subject to vibration; otherwise, they may fall over, causing
damage or injury.
Take the occurrence of earthquakes or other physical shocks
into consideration when selecting the installation place, and
secure the speakers thoroughly.
To prevent deformation or discoloration of the cabinet, do not
install the speakers where they are exposed to direct sunlight or
high humidity, and avoid installation near air conditioning outlets.
Speaker vibrations may cause howling. Place the speakers as
far away from the player as possible.
The speakers are magnetically shielded to avoid color distortions
on TVs. However, if not installed properly, it may cause color
distortions. So, pay attention to the following when installing the
speakers.
When placing the speakers near a TV set, turn off the TV’s
main power switch or unplug it before installing the speakers.
Then wait at least 30 minutes before turning on the TV’s main
power switch again.
Some TVs may still be affected even though you have followed
the above.
If this happens, move the speakers further away from the TV.
Tuner reception may become noisy or hissing if a speaker is
installed near the tuner.
In this case, leave more distance between the tuner and the
speakers or use an outdoor antenna for better tuner reception
without interference from the speakers.
Do not lean against the speakers, as the speakers could fall
down or break, possibly causing an injury. Especially be careful
that children do not lean against them.
Precautions for daily use
To maintain the appearance of the speakers
Wipe with a dry, soft cloth if the cabinet should become dirty.
If very dirty, wipe with a cloth applied a small amount of water
or neutral detergent, then wipe with a dry cloth.
Do not use chemicals such as benzene and thinner for
cleaning the cabinet.
To improve the sound field
It is recommended to leave a space of more than 50 cm
between the speakers and the wall.
If the speakers are facing a solid wall or glass door, etc., it is
recommended to furnish the wall with materials that absorb
sounds, for example by hanging up thick curtains, to prevent
reflections and standing waves.
To use the speakers without any trouble
Do not reproduce sounds at so high a volume that they
are distorted; otherwise, the speakers may be damaged by
internal heat buildup.
When moving the speakers, do not pull the speaker cords;
otherwise, the speakers may fall over, causing damage or
injury.
o
•
–
•
•
•
–
•
•
o
•
–
–
•
–
–
•
–
–
Attaching the feet
To prevent the speaker from falling over, be sure to attach the
supplied feet to the speaker.
Take care not to drop the feet or speaker while assembling;
otherwise, it may cause damage to the floor or injury.
Ensure enough space for assembly and installation.
Place a large, thick cloth on the floor where you assemble the
speaker, so you can protect the floor and the speaker itself.
Do not touch the speaker units.
Turn the speaker upside down.
Turn the speaker and facing the bottom upward.
Caution:
Make sure the speaker does not fall.
Speaker units
Attach the feet.
Attaching the 3 feet on the bottom of the speaker.
Foot x 3
Speaker
section
B Tighten
A Insert
Attach the base.
Prepare a Philips screwdriver.
Attaching the base securely on the feet with the supplied three
screws.
Speaker
section
Screw x 3 (M8 x 40 mm)
Base
Face the surface
with the countersunk
holes upward.
o
•
•
•
•
1.
•
2.
•
3.
•
•
3
English
SX-WD10_Book.indb 4 10/5/2005 AM 10:01:53