JVC SX-DW303 - Manual (Page 6)

– 6 –
Operations
Turning On the Power—POWER Å
Press the ON [ ❙ ] portion of the POWER switch.
The main power turns on and the power lamp in the front panel
lights in green.
• The power lamp lights in red when the AUTO POWER ON/
STANDBY places the unit into standby mode (see page 7).
To completely cut off the power to this unit
Press the OFF [
‡ ] portion of the POWER switch.
This will disconnect the mains lead.
Adjusting the Volume—VOLUME ı
Adjust the volume output level through this unit while comparing
with the sounds coming out of the main (front) speakers.
• Once you have adjusted the volume output level of this unit,
you do not need to adjust it each time you use this unit.
Adjusting the volume level on the connected amplifier will also
adjust the volume level through this unit.
1
Turn the VOLUME knob to the MIN position.
2
Turn on the connected amplifier and start playing a
source.
Playback sounds come out of the main (front) speakers and
this unit.
3
Adjust the VOLUME knob to obtain a well-balanced sound
level with that of the main (front) speakers.
If the volume is set at a high level before starting play, the
sudden blast of sound energy can permanently damage
your hearing and/or ruin your speakers.
MAX
VOLUME
MIN
MAX
VOLUME
MIN
Power
lamp
Front view
Rear view
INPUT 2
TO MAIN
SPEAKERS
(HIGH-LEVEL)
(LOW-LEVEL)
RIGHT
RIGHT LEFT
RIGHT LEFT
LEFT/MONO
MAX
VOLUME
50Hz
200Hz
MIN
CANCEL
ON
ON OFF
REVERSE
NORMAL
FIXED
VARIABLE
INPUT 1
POWER
FREQUENCY
AUTO POWER ON/STANDBY
PHASE CUT OFF FILTER
Е
З
ı З
О
‰
POWER
PHASE
AUTO POWER
ON/STANDBY
VOLUME FREQUENCY
CUT OFF
FILTER
EN_SX-DW303_f.p65 02.7.15, 0:53 PM 6